|
If it can be concepted,
it can be produced by the craftsman
here at C&A Tool. In our engineering
division, engineers work with toolmakers.
This is both a novel and synergistic approach
to design and engineering. Our objective
is to meet your tooling, engineering and
production requirements - with speed,
precision, highest quality and cost effectiveness
- whether your component is a single-piece,
prototype run, interim production run
of a few-hundred pieces, or a high-volume
run of hundreds
of thousands. Our engineering capabilities
include:
- Mold/tool design
- Production/process development
- With high-speed, computerized, modem
receipt and transport of data
Engineering provides
the geometrical support for the
toolmaker and his project development.
Our toolmaker then tracks the project
through tooling and into manufacturing
- whether its our manufacturing or yours
- meeting all production challenges head-on
and solving all technical problems along
the way. Bottom line: our engineering
objective is to put you in production
fast.
|
